Weld-On Hydraulic Thumbs

WELD-ON STYLE HYDRAULIC THUMBS FROM POWER USA FABRICATE ARE ONE OF A KIND. OUR PATENTED DESIGN ALLOWS OUR WELD-ON THUMBS TO BE JUST AS RELIABLE AND FUNCTIONAL AS A PIN-ON UNIT. EXCEPT AT A FRACTION OF THE COST AND WITH LITTLE OR NO WAIT TIME.

READ OVER OUR TWO MEASURING INSTRUCTIONS & INPUT YOUR TWO MEASUREMENTS INTO THE DROP DOWN BOXES ON THE TOP LEFT OF YOUR SCREEN (ON MOBILE PHONES THE DROP DOWN BOXES ARE AT THE VERY BOTTOM OF THE PAGE). THEN BROWSE OUR SELECTION OF WELD-ON THUMBS THAT WILL FIT YOUR MACHINE.

First Measure the width of your smallest/most narrow bucket that you use on your machine. Once you have the width please input the width of your bucket into the drop down box below.

**Please note that your bucket must be wider than your thumb for proper use**

Second step will be to position your bucket & stick as shown in the image below & Measure from the welding surface of the boom/stick to the tip of the teeth or edge on your bucket.

**Please note that the measurement taken with the stick and bucket at 90 degrees (shorter measurement) is the measurement that you will input into the drop down box below**

Second step will be to position your bucket & stick as shown in the image below & Measure from the welding surface of the boom/stick to the tip of the teeth or edge on your bucket.

**Please do not input this measurement into the drop down boxes below. This measurement is for engineering purposes only & will be saved until you actually go through the checkout/purchase process.**